Select key values (ANLD5521)

This panel is only displayed if you completed the From, To and/or Mask fields with dots during the Key selection process when defining your columns, versions and/or lines.

Note: This information is only applicable if you are working in the DC1 5250 and JWalk environments: At the far right, within brackets, the length and field type is displayed for each key field. A means that the key field is an alphanumeric field (can consist of both characters and digits) X means that the key field is a numeric field (can only consist of digits).

For example:

Balance type

Displays the selected balance type and its description.

Key no

Displays the statistical key number that you filter values on.

Description

Displays a description of the selected key.

From, To and/or Mask

Only the fields that were completed with dots during the key selection process are displayed. The result is dependent on what you complete.

For example:

Fields displayed	Completion	Result
From	Leave it blank	The selection starts at the lowest value.
To	Leave it blank	The selection starts at the highest value.
From and To	Enter a range of values	Will receive all permitted values starting with the entered from value, up to and including the entered to value.
From, To and Mask	Leave all fields blank	The system will select everything.
From, To and Mask	If, e.g., From value is 1000 and To value is 3000 and you enter a Mask of 4___	You will not receive any values on the printout.
From, To and Mask	If, e.g., From value is 1000 and To value is 3000 and you enter a Mask of 2___	You will receive all values starting with 2.
Mask	Leave it blank	The system will select everything.

TCP

This field is only displayed if the key is allowed for TCIP/TCP (Table-controlled interval printout) in the Statistic key definitions. Enter any character in the field to enable TCP. Only one key can be selected. Note: Table-controlled interval printout (TCP/TCIP) will override selections on columns and lines.